Emc921F - EverFocus eZ.HD Series User Manual

6. Adjust the camera angle by rotating the camera. After adjusting the camera angle, tighten the
three cover screws using the supplied Hexagon Wrench.

3.1 EMC921F

Screw Hole
Optionally thread the
cable through this hole
1. Attach the Camera Bracket to the surface where you want to mount the camera and mark the
Screw Hole locations on the surface. Drill two screw holes on the surface and insert the
supplied two Anchors to the holes. Screw the Camera Bracket to the surface using the supplied
two Screws.
2. Optionally drill another hole in the middle between the two screw holes only if you want to
thread the cables through the surface.
3. To adjust the Camera angle, loosen the two screws on both sides of the camera and then adjust
the angle.
4. Connect the Power Cable to a 12VDC power source. Connect the Video Output Cable to a
monitor or DVR.
1
2
1
Screw Hole
EMC921F/EMW921F eZ.HD Mobile IR Mini Camera
3 Loosen to adjust Camera Angle
3
Loosen to adjust Camera Angle
4
5
Power Cable
Video Output Cable