2. Attach the camera base to the mounting surface to mark the four screw holes on the mounting
surface. You can optionally mark a cable hole only if you want to run the cables through the
mounting surface. Drill the marked screw holes and cable hole on the mounting surface.
3. Screw the camera base to the surface using the supplied four Screws.
4. Place the camera back to the base, and then screw the cover back to the base.
Remark: Do not screw the cover too tight at this stage as you will have to adjust the camera
angle later.
5. Connect the Power Cable to a 12VDC power source. Connect the Video Output Cable to a
monitor or DVR.
EMC921F/EMW921F eZ.HD Mobile IR Mini Camera
Cable Hole
Camera
Power Cable
Video Output Cable
4
Cover