TRENDnet User's Guide
Weather Conditions
The TV‐IP312PI is a small bullet camera, which fits most installations indoor
and outdoor. The camera can work under a wide range of weather conditions.
For severe weather conditions, a camera housing with temperature and
moisture control is recommended. Using the camera in milder weather
conditions will help extend the camera's product life and preserve the quality
of the video image.
• Moisture: Avoid damp or moist environments whenever you can. The
TV‐IP312PI is an IP66 grade water proof camera, and it will work in
moist environments. However, rain may affect the picture quality,
especially at night, water may reflect the light from the infra‐red
illumination and degrade picture quality.
• Temperature: TV‐IP312PI works within a specified temperature range.
Areas with severe temperatures should be avoided when installing the
camera. It's recommended that you use an enclosure with a heater and
blower if you plan on using this camera outside of the specified
temperature range.
• Sunlight: Avoid direct sun light exposure. Direct sun light will damage
the image sensor. If sunlight is necessary for your viewing purposes,
provide protection for the image sensor.
• Lighting: Consider installing your camera faces the same direction of
the light sources. Shooting images with top‐down position outdoor or
next to the existing light source are good choices. Avoid the light source
if it creates a shade that darkens the viewing area.
© Copyright 2017 TRENDnet. All Rights Reserved.
Hardware Installation
Cabling
It's recommended that the wiring the cable in your home or office by a
professional. If you already have the cable deployed, make sure the cable and
the connectors meet the category 5 Ethernet cable standards. At least 2 pairs
of twisted lines are required for power and data. Poor cable quality may cause
unexpected problems. Testing your cable or running a new cable is suggested
for new camera installation.
Waterproof cap
The TV‐IP312PI itself is IP66 grade water and dust proof. There is a set of
network cable water proof caps that comes with the package as well. Run
your cable going through the accessories, and then crimp the cable with an
RJ45 module. Plug in the network cable and then tighten the waterproof cap
to prevent water running into camera through the cable.
TV‐IP312PI
8