Table of Contents
Advertisement
TRENDnet User's Guide
Cautions
Injury or equipment damage may be caused if any of these cautions are
neglected. Follow these precautions to prevent potential injury or material
damage.
• Make sure the power supply voltage is correct before using the Camera.
• Do not drop the camera or subject to physical shock.
• Do not touch sensor modules with fingers. If cleaning is necessary, use
a clean cloth with a bit of ethanol and wipe it gently. If the camera will
not be used for an extended period of time, put on the lens cap to
protect the sensor from dirt.
• Do not aim the camera lens at the strong light such as the Sun or an
incandescent lamp. Strong light can damage the camera sensor.
• The sensor may be burned out by a laser beam, so when any laser
equipment is being used, make sure that the surface of the sensor will
not be exposed to the laser beam.
• Do not place the camera in extremely hot, cold temperatures (the
operating temperature should be between ‐10°C to 60°C), dusty or
damp environment, and do not expose it to high electromagnetic
radiation.
• To avoid heat accumulation, good ventilation is required for a proper
operating environment.
• Keep out of water and any liquid.
• While shipping, the camera should be packed in its original packing.
© Copyright 2017 TRENDnet. All Rights Reserved.
Installation Procedure
There are number of factors involved in a successful camera installation.
Follow the suggested installation steps and go through the check lists. This
guide will help you make your camera installation smoothly and easily.
Plan for installation location
Viewing angle
The TV‐IP312PI is a bullet camera with a focused viewing angle (70 horizontal)
that provides non‐distorted and detailed images. Choose the location where
has good angle to shoot the image you expect to see. The motion detection
area should also be considered when installing the camera.
TV‐IP312PI
7
Advertisement
Table of Contents
