Table of Contents
Advertisement
Storage
Storage Safety
•
Shut off the machine, remove the key (if equipped),
and wait for all movement to stop before you leave
the operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
Preparing the Machine for
Storage
If you wish to store the machine for a long period of
time, the following steps should be performed prior
to storage:
1.
Refer to
Storage Safety (page
2.
Remove accumulations of dirt and old grass
clippings. Sharpen the blades and bedknives, if
necessary; refer to the cutting unit Operator's
Manual. Use a rust preventive on bedknives and
blades. Grease and oil all lubrication points.
3.
Block up the wheels to remove any weight on
the tires.
4.
Drain and replace the hydraulic fluid and filter
and inspect the hydraulic lines and fittings.
Replace, if necessary; refer to
Engine Oil and Filter (page 31)
the Hydraulic Lines and Hoses (page
5.
All fuel should be removed from the fuel tank.
Run the engine until it stops from lack of fuel.
Replace the fuel filter; refer to
Fuel Filter (page
6.
While the engine is still warm, drain the oil from
the crankcase. Refill it with fresh oil; refer to
Changing the Engine Oil and Filter (page
7.
Clean dirt and chaff from the cylinder, cylinder
head fins, and blower housing.
8.
Remove the battery and charge it fully. Either
store it on the shelf or on the machine. Leave
the cables disconnected if it is stored on the
machine. Store the battery in a cool atmosphere
to avoid quick deterioration of the charge in the
battery.
9.
If possible, store the machine in a warm, dry
location.
44).
Changing the
and
Checking
40).
Replacing the
32).
31).
44
Advertisement
Table of Contents
