Table of Contents
Advertisement
Figure 21
1. Backup lever
Reel-Speed Control
Use the reel-speed control
speed of the reels.
Specifications
Note:
Specifications and design are subject to
change without notice.
Width of cut
Wheel tread
Wheel base
Overall length (w/baskets)
Overall width
Overall height
Net Weight w/reels (8 Blade)
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
2. Reel-speed control
(Figure
21) to adjust the
151 cm (59.5 inches)
128 cm (50.5 inches)
119 cm (46.9 inches)
249 cm (98.0 inches)
179 cm (70.6 inches)
205 cm (80.8 inches)
633 kg (1,395 lb)
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Before Operation
Before Operation Safety
g007385
General Safety
•
Never allow children or untrained people to
operate or service the machine. Local regulations
may restrict the age of the operator. The owner
is responsible for training all operators and
mechanics.
•
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
•
Shut off the engine, remove the key (if equipped),
and wait for all movement to stop before you leave
the operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Know how to stop the machine and shut off the
engine quickly.
•
Check that operator-presence controls, safety
switches, and safety protective devices are
attached and functioning properly. Do not operate
the machine unless they are functioning properly.
•
Before mowing, always inspect the machine to
ensure that the cutting units are in good working
condition.
•
Inspect the area where you will use the machine
and remove all objects that the machine could
throw.
Fuel Safety
•
Use extreme care in handling fuel. It is flammable
and its vapors are explosive.
•
Extinguish all cigarettes, cigars, pipes, and other
sources of ignition.
•
Use only an approved fuel container.
•
Do not remove the fuel cap or fill the fuel tank
while the engine is running or hot.
•
Do not add or drain fuel in an enclosed space.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
•
If you spill fuel, do not attempt to start the engine;
avoid creating any source of ignition until the fuel
vapors have dissipated.
17
Advertisement
Table of Contents
