Troubleshooting - Blodgett XCEL-50EC Installation & Operation Manual

ERROR CODE
"FAN ERROR" or
"FAN DRIVE ERROR"
"ERROR"
"STRIKE SWITCH"
"HEAT SINK ERROR"
"HIGH LIMIT ERROR"
"ERROR"
"DOOR NOT LOCKED"
"HI LIMIT TEMP" or
"FAIL-HI LIMIT TEMP"
"HI TEMP" or
"FAIL-HI TEMP"
"BAD DRIVE PROBE"
"CALL FOR SERVICE"
"PROBE OPEN or
"PROBE SHORT"
or
"FAIL-PROBE OPEN" or
"FAIL-PROBE SHORT"
"FAIL-COOK HEAT"
DESCRIPTION
Problem with the blower
Problem with the door switch
An oven component has overheated.
Check that the cooling fan in the rear
of the oven is not blocked.
The oven has overheated and
tripped the high limit
Problem with the door lock mecha-
nism in the CLEAN or DELIME mode
The oven temperature is greater than
565°F.
The oven temperature is 150° above
the set point
An oven component has
overheated
The temperature probe has failed
The oven temperature doesn't rise
2°F within 5 min.
Problem with the heating elements
13
Operation

Troubleshooting

ACTION
Turn oven off for 30 seconds and then
back on. If the error repeats, call for
service
Call for service
Call for service
Call for service
Call for service
Turn oven off and call for service
Make sure set points are
programmed correctly
Make sure the correct product key
has been selected
Make sure set points are
programmed correctly
Check that the cooling fan in the rear
of the oven is not blocked. Call for
service
Call for service
Call for service