Graco G3 Instructions Manual page 6

Instructions
vent damage, hold low level paddle in its full out
position while installing stirring paddle (F
F . 13
IG
5. Step 5 (a - g) is for G3 Pumps with a follower
plate ONLY. If your G3 Pump does not include a
follower plate, continue Reservoir Installation
instructions, page 7.
a. Verify low level paddle (e) is in full out position
as shown in F
IG
F . 14
IG
6
. 14).
IG
. 14.
e
b. Install follower plate (FP) on stirring paddle (4).
Be sure the seal (FPS) is facing down (toward
ricer plate) as shown in F
4
k
F . 15
IG
c. Install spring (S) into spring pocket (k).
d. Install Rod (R) into reservoir (a).
e. Slide rod (R) through center of spring (S) and
follower plate (FP).
f. Seat spring (S) in spring pocket in top of reser-
voir (a).
g. Compress spring (S) to install reservoir (a). See
Reservoir Installation instructions.
. 15.
IG
R
S
FP
FPS
4
3A0535C