Graco G3 Instructions Manual page 5

b. Examine low level paddle (e). It is designed with
a slot / gap on one side.
j
F . 9
IG
c. To correctly assemble the low level paddle (e) to
the stirring paddle (4), slide the stirring paddle
and washers into the slot / gap (F
e
slot/gap
g
F . 10
IG
d. Align hole (j) in top of low level paddle (e) with
hole in center of washers (g) and stirring paddle
(4) (F . 11).
IG
3A0535C
e
slot / gap
. 10).
IG
4
e. Insert bolt (f), making sure it passes through the
low level paddle (e), holes in washers (g) and
base of stirring paddle (4) (F
e
g
F . 11
IG
f. Using a screwdriver, tighten bolt (d). Torque bolt
to 4 in. lbs (0.45 N•m). Bolt should be tight
enough to the hold low level paddle securely in
place while still allowing the paddle to move
freely back and forth. It also must not protrude
from the bottom of low level paddle (e).
NOTE: Over tightening bolt (d) will cause low
level paddle to not function.
g. Install bearing (2) in paddle (4) as shown in F
12.
4
F . 12
IG
4. Install stirring paddle (4) in base of G3. Turn paddle
counter-clockwise until it is tighten securely in
place (F . 13). (Illustration does NOT show low
IG
level paddle.)
NOTE: If a low level paddle (e) is installed, to pre-
Instructions
. 11).
IG
f
j
4
IG
2
.
5