Graco G3 Instructions Manual page 4

Instructions
7. Step 7 (a - b) is for G3 Pumps with Low Level
Paddle ONLY:
a. Remove bolt (f) and washers (g) holding low
level paddle (e) to stirring paddle (d) and com-
pletely separate these parts from stirring pad-
dle. Keep bolt and washers for reassembly (F
6.
g
F . 6
IG
b. Examine the low level paddle (e), if undamaged
it can be reused. If damaged, a replacement low
level paddle, part no. 278136 is available from
Graco customer service.
8. For all installations, discard old stirring paddle (d)
(this part is not reused).
4
e
f
e
d
Reassembly
Always use new parts from kit when available.
1. Lightly grease stirring paddle arm (4a) with same
grease you are using in the pump (F
.
IG
F . 7
IG
2. Slide wiper (1) over arm (4a) on stirring paddle (4)
(F . 7).
IG
3. Step 3 (a - g) is for G3 Pumps with Low Level
Paddle ONLY. If your G3 Pump model does not
include a Low Level paddle, continue installa-
tion with Step 4, page 5.
To assemble low level paddle to stirring paddle (4):
a. Align washers (g), with hole in the base (h) of
the stirring paddle (4). One washer should be
on the top of the hole and one on the bottom
(underside) as shown in F
h
F . 8
IG
. 7).
IG
1
4a
4
. 8.
IG
g
4
g
3A0535C