Fan Head Assembly - Bionaire BSF1613EG Instruction Manual

Models BSF1613EW and BSF1613EB:
A. Front Grill
B. Fan Blade Lock Nut
C. Fan Blade
D. Rear Grill Nut
E. Rear Grill
F. Motor Shaft
G. Motor Housing
H. Handscrew
I. Control Panel
J. Expandable Pole
K. Height Adjustment Knob
L. Base
M. Weight
N. Screw/Washer/Knob Assembly
O. Power Button
G
F
H
I
J
K
L
M
N
Control Panel
O
P
Q
BSF1613_BSF1615-LA_16MLM2.indd 2
E
D
C
B
A
T
BSF1613EB/BSF1613EG/
BSF1613EL/BSF1613EW/
BSF1615EB
Remote Control
O
Q
P
S
R
P. Breeze/Sleep Mode Button
Q. Timer Button
R. Speed Button
S. Oscillation Button
T. Grill Ring
BASE / POLE ASSEMBLY
1. Extend the upper pole through the top of the lower
pole and secure it firmly by turning the height
adjustment knob clockwise.
2. Remove the screw/washer/knob assembly from the
pole by turning counter-clockwise.
3. Insert the screw/washer/knob assembly through
the weight and base into the lower pole, and turn
clockwise until tight.

FAN HEAD ASSEMBLY

You are now ready to assemble the fan head.
1. Remove plastic sleeve on motor shaft, if included.
Position the rear grill over the motor shaft, making
certain the 2 notches at the top and 1 notch at the
bottom of the rear grill fit over the protruding notches
on the motor housing. Make sure the rear grill fits
securely against the motor housing.
2. Fasten the rear grill in place using the rear grill nut.
Turn the nut clockwise and tighten firmly.
3. Slide the fan blade, with the hollowed interior of the
fan blade facing toward the rear grill, firmly onto the
motor shaft. Make sure that the fan blade rests on
the pin on the motor shaft.
NOTE: The shaft screw portion should protrude
from the front of the blade.
4. Secure the fan blade onto the motor shaft by
turning the blade cap counter-clockwise (make sure
the blade is firmly in position).
5. Center the front grill, ensuring the Bionaire™ logo is
horizontal and parallel to the floor, and press onto
rear grill after aligning snaps.
For Models BSF1615MB and BSF1615EB, please
see below.
6. Center the front grill by aligning the BIONAIRE
on the logo plate so it is horizontal and parallel with
R
the floor. Holding the front grill against the rear grill,
push the grill ring into place at the top and bottom of
the fan. (Push directly on the grill ring, not on the grills
S
themselves). Finish securing the grill ring in the same
manner until both grills are joined underneath the ring.
7. Close the grill ring with the grill lock screw provided
at the bottom of the grill (see Figure 2).
Figure 2
2
logo
®
BSF1615MB and
BSF1615EB only
7/4/16 9:23 AM