Wall Installation Instructions; Fan Head Assembly; Assembly Instructions; Operating Instructions - Bionaire BWLF1613MW Instruction Manual

WALL INSTALLATION INSTRUCTIONS

1. Select a suitable spot on the wall (away from curtains, draperies, windows, doors,
heat sources or electrical connections) where you want to mount the fan and in close
proximity to the power supply.
2. Install the installation plate on the wall with holes on the bottom. Mount the fan on the
installation plate. Note that the base of the fan must be mounted vertically (see figure 1).
3. The installation plate must be installed using the appropriate anchoring hardware and/
or fastener for the wall surface application.
CAREFULLY check fan for proper mounting.

FAN HEAD ASSEMBLY

You are now ready to assemble the fan head.
1. Remove plastic sleeve on motor shaft, if included. Position the rear grill over the
motor shaft, making certain the 2 notches at the top and 1 notch at the bottom of the
rear grill fit over the protruding notches on the motor housing. Make sure the rear grill
fits securely against the motor housing.
2. Fasten the rear grill in place using the rear grill nut. Turn the nut clockwise and tighten
firmly.
3. Slide the fan blade, with the hollowed interior of the fan blade facing toward the rear
grill, firmly onto the motor shaft. Make sure that the fan blade rests on the pin on the
motor shaft.
NOTE: The shaft screw portion should protrude from the front of the blade.
4. Secure the fan blade onto the motor shaft by turning the blade cap counter-clockwise
(make sure the blade is firmly in position).
5. Center the front grill, ensuring the Bionaire
and press onto rear grill after aligning snaps.
1. Once unit is fully assembled and installed on the wall, plug it into an appropriate
electrical outlet.
2. Pull the RIGHT CONTROL CORD down or turn the SPEED KNOB to select the
desired fan speed or to turn it off: "0" ifor "OFF", "1" for Low Speed, "2" for Medium
Speed and "3" for High Speed (see figure 1).
3. To start or stop the head oscillation, pull the LEFT CONTROL CORD down.
NOTE: CAREFULLY PULL ON FAN CORD CONTROLS. EXCESSIVE FORCE MAY
DAMAGE FAN AND MAY CREATE AN ELECTRICAL HAZARD.
BWLF1613MW-LA_14ESM1.indd 4
INSTRUCTIONS FOR USE

ASSEMBLY INSTRUCTIONS

OPERATING INSTRUCTIONS

logo is horizontal and parallel to the floor,
®
3
6/9/14 5:13 PM