Fan Head Assembly - Bionaire BMSF1622S Instruction Manual

ASSEMBLY
INSTRUCTIONS
A. Front Grill
B. Fan Blade Lock Nut
C. Fan Blade
D. Rear Grill
E. Motor Shaft
F. Motor Housing
G. Oscillation Button
H. Insect-Repellent Tablet Diffuser Compartment
I. Tablet Compartment Tray
J. Remote Control
K. Expandable Pole
L. Base
A B C
BASE / POLE ASSEMBLY
1: Extend the upper pole through the top of the
lower pole and secure it firmly by turning the
height adjust knob clockwise.
2: Insert the bottom of the lower pole into the hole
on the top of the base.
G H
D E F
J
K
L

FAN HEAD ASSEMBLY

You are now ready to assemble the fan head.
1: Position the rear grill over the motor shaft,
making certain the 3 notches at the top and
bottom of the rear grill fit over the 3 protruding
notches on the motor housing. Make sure the
rear grill fits securely against the motor housing.
(Figure 1)
2: Fasten the rear grill in place using the rear grill
nut. Turn the nut clockwise and tighten firmly.
(Figure 1)
3: Slide the fan blade; with the hollowed interior of
the fan blade facing toward the rear grill firmly
onto the motor shaft. The blade has "D" type
hole that matches the tip of the motor shaft.
These two should be aligned so that the blade
can be properly assembled. Make sure that fan
blade rests on the pin on the motor.
NOTE: The shaft screw portion should protrude
from the front of the blade.
4: Secure the fan blade onto the motor shaft by
I
turning the blade cap counter-clockwise (make
sure the blade is firmly in position.) (Figure 1)
5: Center the front grill, aligning the Bionaire™ logo
so it is horizontal and parallel to the floor, place
onto the rear grill, and snap in place by pushing
front grill onto shroud clips. Make sure to secure
the locking-clip on the bottom of the rear grill.
(Figure 2) You should hear a click.
Fig. 1
Fig. 2
2
Fig. 3
HASF 152RTTG 11/02