Fan Head Assembly; Final Assembly - Bionaire BSF1731 Instruction Leaflet

FAN HEAD ASSEMBLY

TRIM CAP
Figure 2 Figure 4
Figure 3 Figure 5
Step 1: Position the rear grill over the motor shaft, making
certain the cut outs in the center of the grill fit over the prongs on the
motor housing. Please make sure the rear grill fits securely against the
motor housing.
Step 2: Secure the rear grill in its place using the rear grill mounting-
ring. Turn this ring clockwise and tighten firmly.
Step 3: Slide the fan blade, with the hollowed interior of the blade fac-
ing toward the rear grill, firmly onto the motor shaft. Make sure that the
pin through the motor shaft aligns with the groove in the back center of
the fan blade.
Step 4: Secure the fan blade onto the motor shaft by firmly tightening
the fan blade nut.
NOTE: TURN THE FAN BLADE NUT COUNTER-CLOCKWISE
Step 5: Align the tabs on the grills, and press grills firmly against each
other. (Figure 2)
Step 6: Place grill ring over attached front and rear grills with connect-
ing link centered over the top of the grill. Make sure to fit the grooves
on the underside of the grill ring over the edge of the front and rear
grills. (Figure 3)
Step 7: Secure the grill ring to the front and rear grills using the fixed
screw. Place the trim cap over the connecting link and snap into place.
(Figures 4 & 5)

FINAL ASSEMBLY

FOR REMOTE VERSION
Step 1: Slide the remote control housing over the upper pole and
secure the housing with the fan post screw.
FINAL ASSEMBLY
FOR NON-REMOTE VERSION
Step 1: Slide the threaded end of the fan head pole, into the top of the
pole. Holding the neck of the fan, turn it counterclockwise until it locks
into position.
NOTE: Make sure the top of the upper pole is facing away from you
when placing the fan head into the pole.
3