Fan Head Assembly - Bionaire BSF16 Instruction Leaflet

FAN HEAD ASSEMBLY

Step 1. Attach the neck of the fan to the
upper extension pole. To do this, align
the extension pole clasps and screw
holes up with the corresponding holes
on the neck of the fan. Once you have
the neck adjusted to the angle of the
extension pole clasps, screw the clasps
to the neck of the fan until secure.
Step 2. Using your screwdriver, remove
the securing screw that is located inside
the Bionaire decorative cap on the grill
®
ring. Once you have unscrewed the grill
ring, put it aside until you are ready to re-
attach the grills.
Step 3. Remove the two plastic ties that
are holding the rear grill and the fan blade together. Discard the two
plastic ties and cardboard.
Step 4. Loosen and take off the rear grill mounting nut ( H ) that is
attached to the motor housing by turning counter-clockwise.
Step 5. Place the rear grill on the front of the motor housing; making
sure that the handle on the back of the grill is above the motor housing
(doing this will align the holes on the grill over the two screws in the
housing). Then tighten the rear grill mounting nut onto the rear grill by
turning clockwise.
NOTE : To know that the rear grill is on correctly, there will be one grill
clip located at the bottom of the grill.
Step 6. Place the fan blade onto the motor shaft ( J ) making sure to
align the flat area on the motor shaft with the flat area in the center of
the fan blade. Slide the fan blade to the back of the motor shaft until it
stops and the motor shaft is protruding.
Step 7. Insert the washer and tighten the nut onto the motor shaft to
secure the fan blade. Complete the fan blade assembly by turning
the fan blade cap counter-clockwise into the matching grooves in the
center of the fan blade.
Step 8. Place the front grill onto the back grill so that the 2 clips on the
top of the front grill fit over the rear grill. Also ensure that the bottom
clip that is attached to the rear grill, attaches and fits onto the front grill
when assembling the fan head.
NOTE: When attaching the grill ring, make sure to have the Bionaire ®
decorative cap (where the two ends of the grill ring meet)
at the bottom, center of the grills.
3