Hach 2100AN Instrument Manual page 68

SECTION 6,
continued
A. Baud Rate Select:
1. Press (the small LED mode display flashes).
SETUP
2. Use the up, down and right arrow keys to enter
3. Press .
ENTER
4. The current baud rate flashes in the large display (1200 is the factory setting).
5. Use the up or down arrow keys to select the desired baud rate.
6. To store, press
ENTER
7. Press to exit the setup mode.
SETUP
B. Character Length Select:
1. Press (the small LED mode display flashes).
SETUP
2. Use the up, down and right arrow keys to enter
3. Press .
ENTER
4. The current character length flashes in the large display.
5. Use the up or down keys to select the desired character length.
6. To store, press
ENTER
7. Press to exit the setup mode.
SETUP
C. Stop Bit Select:
1. Press (the small LED mode display flashes).
SETUP
2. Use the up, down and right arrow keys to enter
3. Press .
ENTER
4. The current number of stop bits flashes in the large display.
5. Use the up or down keys to select the desired stop bits.
6. To store, press
ENTER
7. Press to exit the setup mode.
SETUP
D. Parity Select:
1. Press (the small LED mode display flashes).
SETUP
2. Use the up, down and right arrow keys to enter
3. Press .
ENTER
4. The current parity selection flashes in the large display.
5. Use the up or down arrow keys to select the desired parity.
68
.
.
.
into the mode display.
10
into the small display.
11
into the mode display.
12
into the mode display.
13