Relevant Models - Kenwood TS-990S Setting Manual

1. Relevant Models

This operations guide is for the TS-990S.
Using the TS-990S and the KENWOOD NETWORK COMMAND SYSTEM
(hereinafter called "KNS") enables transceiver operations by remote control
using a home LAN or the Internet.
KNS is a system configured using PCs, network environments, ARCP-990 (a
Radio Control Program; hereinafter called "ARCP-990"), ARHP-990 (a Radio
Host Program; hereinafter called "ARHP-990"), and ARVP-10 (a VoIP Program;
hereinafter called "VoIP Program") for remote control of the TS-990S.
Note: If the firmware version of the TS-990S is V1.00, please update it to V1.01
or later.
Important
To configure the system, knowledge not only of transceivers but also of

PCs and networks is required. JVC KENWOOD does not offer support for
customer PCs and Networks. Furthermore, for operations relating to
actual transmitting, note that procedures according to the Radio Act are
also required.
Operations via networks may be delayed due to unavoidable principles.

Consequently, do not perform operations (such as contests or pile-ups
requiring quick responses) for which delays are likely to be a problem.
Even if you set by the procedures described in this document, the feature

may not work properly because of the combination of PC, the network
environment and the sound device.
Refer to "5. Limitations

JVC KENWOOD Corporation shall bear no responsibility for related

damage such as damage caused by missed communications and dialog
opportunities due to incorrect customer settings, nonconformances, or
misoperations as a result of using this document or the ARCP-990,
ARHP-990 or ARVP-10 software.
Caution!" for other limitations.
2