Kenwood TS-990S Setting Manual page 25

Installation
Connection
Question
I want to use a USB headset
or Bluetooth headset on the
remote station PC. Will there
be any problems?
Cannot operate the
transceiver.
Cannot connect to the host
station.
You can use them, but in
principle, a USB headset or
Bluetooth headset has
unavoidable delays, so entering
standby will take considerable
time. If the delays are a
problem, it is better to avoid
using them.
After connecting a USB headset
or Bluetooth headset, you must
set the default recording and
playback devices using the
Windows sound settings. For
details, refer to the USB headset
or Bluetooth headset user
manual.
Check the environment of the
PC at the remote station.
・ Select "KNS (KENWOOD
NETWORK COMMAND
SYSTEM) (ARHP-990)" from
"Settings" in the "Tool" menu
on the ARCP-990, and click
"Settings".
If the choice of the IP
address is blank, the IP
address has not been able to
be obtained. Check that the
network devices are working
properly.
・ If the choice of the IP
address has several
selections, select the IP
address that is used to
connect to the network.
Check the environment of the
PC at the host station.
・ Select "Configure KNS" from
the "Tool" menu on the
ARHP-990.
If the choice of the IP
address is blank, the IP
address has not been able to
be obtained. Check that the
network devices are working
properly.
・ If the choice of the IP
address has several
selections, select the IP
address that is used to
connect to the network.
24
Answer