Settings; Transceiver Settings; Setting Up An Audio Input Route From The Rear Terminal; Audio I/O Level Settings - Kenwood TS-590SG Setting Manual

4. Settings

4.1 Transceiver Settings

Complete the necessary transceiver (TS-590SG) settings before using the USB audio
function. (Refer to the user manual for how to use the TS-590SG.)

4.1.1 Setting Up an Audio Input Route from the Rear Terminal

On the rear terminal there are two types of audio input routes – the ACC2 connector
route and the USB connector route for using the USB audio function. Make the
following menu settings to transmit audio input from the USB connector.
Menu No.
69
The default setting is ACC2.

4.1.2 Audio I/O Level Settings

Use the following menu to adjust audio transmission input levels from the PC, and
receive audio output levels to the PC.
Menu No.
71
72
The default value for all settings is 4.

4.1.3 Mixed Beep Setting to External Audio Outputs

With the TS-590SG default mode, only received audio signals that do not include
beeps or side tones are output as audio signals from the ACC2 connector and the USB
connector as USB audio signals.
Make the following menu settings to output the same audio as the audio output from
the wireless speaker, including beeps and side tones, externally.
Menu No.
75
The default setting is OFF.
Function
Audio input line selection for data
communications
Function
Audio level of USB input for data
communications
Audio level of USB output for data
communications
Function
Mixing beep tones for ACC2/USB audio
outputs
6
Set value
USB
Setting range
0 to 9
0 to 9
Set value
ON