Attaching The Roll Core - Epson SC-F9400H Series Operator's Manual

SC-F9400H Series/SC-F9400 Series Operator's Guide
Deformed

Attaching the Roll Core

Preparing
Get a take-up roll core that is the same width as the
media.
Get a commercially available adhesive tape.
Loading
A
After confirming that the media is loaded
correctly, keep the d button pressed until the
edge of the media reaches the roll core holder.
Basic Operations
c
Important:
Always press the d button to feed the media. If
the media is pulled by hand, the media may
twist during take-up.
B
Loosen the roll core holder fixing screws on both
sides and adjust the roll core holders so that the
distance between the two is wider than the media.
If the roll supports are not positioned evenly,
move them so that they are even.
c
Important:
If the left-side roll core handle's shaft is not
visible, rotate the handle as shown in the
illustration until it stops. The roll core cannot
be properly loaded if the handle's shaft is not
visible.
16