Table of Contents
Advertisement
9 9 . . 1 1 3 3 . . 3 3 . . 4 4 I I n n s s t t a a l l l l t t h h e e F F i i l l t t e e r r P P u u m m p p
Installing the filter pump to the filter motor is difficult because the internal pump
propeller is offset slightly. To easily assemble the filter pump to the motor, do the
following:
Place the new filter motor on a flat, sturdy flat surface.
1 1 ) )
Obtain the filter pump, and orient it so the double notches on the housing are
2 2 ) )
facing down.
With one sharp motion or snap, give the filter pump a downward shake. The
3 3 ) )
rollers and propeller snap in to alignment.
Without changing the orientation of the filter pump, slide it on to the filter motor's
4 4 ) )
shaft, ensuring it is fully engaged.
Install the four screws holding the filter pump to the filter motor.
5 5 ) )
9 9 . . 1 1 3 3 . . 4 4 F F i i l l t t e e r r P P u u m m p p / / M M o o t t o o r r I I n n s s t t a a l l l l a a t t i i o o n n
Install the filter pump/motor assembly by doing the following:
Install the filter pump/motor using four nuts and washers that hold the pump to
1 1 ) )
the frame, and leave loose.
Install the wire conduit and jam nut, which holds the wire conduit to the side of
2 2 ) )
the filter motor.
Connect the L1 and L2 power wires from the conduit to the filter motor
3 3 ) )
connections. Refer to the wiring diagram on the data plate for specific locations
and connections.
Using a Phillips head screwdriver, install the access cover on the rear of the
4 4 ) )
filter motor.
Figure 9-4 Pump Rollers
119
Advertisement
Table of Contents
