Ricoh Aficio MP C300 Operating Instructions Manual page 121

1. Press [Reduce / Enlarge].
2. Press [Dir. Size Mag. inch].
3. Enter the horizontal size of the original with the number keys, and then press [ ].
4. Enter the horizontal size of the copy with the number keys, and then press [ ].
5. Enter the vertical size of the original with the number keys, and then press [ ].
6. Enter the vertical size of the copy with the number keys, and then press [ ].
7. Press [OK] twice.
• The horizontal and vertical length of an original can be entered in steps of 1 mm (0.1 inch). The
horizontal length of an original can be 1 to 9999 mm (0.1 to 99.9 inches); the vertical length of an
original can be 1 to 999 mm (0.1 to 99.9 inches). The horizontal and vertical length of copies can
also be entered in steps of 1 mm (0.1 inch). Both the horizontal and vertical length of copies can be
1 to 999 mm (0.1 to 99.9 inches).
• To change the value you entered, press the key you want to change, and then enter a new value.
• The machine selects reproduction ratios of between 25 and 400%. However, if the originals are
placed in the ADF, the maximum reproduction ratio is 200%. To copy originals at a reproduction
ratio above 200%, you must place them on the exposure glass.
• When entering a size in mm (inch), if the calculated ratio is over the maximum or under the minimum
ratio, it is automatically adjusted to within available range. However, with some ratios, parts of the
image might not be copied or margins will appear on copies.
Advanced Reduce/Enlarge Copying
4
119