Changing Monitor Settings - Siemens SIMATIC KTP400 Basic Operating Instructions Manual

5.5

Changing monitor settings

NOTICE
Orientation of the screen for KTP400 Basic and KTP600 Basic
The screen orientation is defined by the configuration engineer in the course of project
creation. The appropriate screen orientation is set automatically when you transfer the
project to the HMI device.
Do not make any changes to the screen orientation if a project exists on the HMI device.
The screen content may otherwise be truncated.
Note
Immediate start of the project with a delay time of 0 seconds
The project starts immediately if a delay time of 0 seconds is set. However, this setting
prevents you from calling the loader after having powered on the HMI device. To handle this
situation, you need to configure an operator control with the "Close project" function.
KTP400 Basic, KTP600 Basic, KTP1000 Basic, TP1500 Basic
Operating Instructions, 08/2008, A5E01075587-01
1. Press the "OP" button to open the
"OP Properties" dialog.
2. Basic Panels color:
Press the "UP" and "DOWN" buttons to adjust
5
the screen brightness.
Basic Panels mono:
Press the "UP" and "DOWN" buttons to adjust
the screen contrast.
3. Only for KTP400 and KTP600:
Select the screen orientation:
– "Landscape" for landscape
KTP400
– "Portrait" for portrait
KTP600
3
4. Set the delay time in the "Delay time" text
box. The delay time in seconds defines the
waiting time expiring between the appearance
of the loader and the start of the project.
Valid range of values: 0 s to 60 s.
4
5. Close the dialog and save your entries with
"OK".
Configuring the operating system
5.5 Changing monitor settings
53