Toro Z Master Commercial 3000 Series Operator's Manual page 58

Figure 84
1. Deck-lift pedal
2. Height-of-cut pin
6. Insert the height-of-cut pin into the 7.6 cm (3
inch) position.
7. Release the transport lock and allow the deck to
lower to the cutting height.
8. Raise the discharge chute.
9. On both sides of the deck, measure from the
level surface to the front tip of the blade (Postion
A). The measurement should read 7.6 mm (3
inches) (Figure 85).
Figure 85
1. 7.6 cm (3 inches) at A is
correct
2. 8.3 cm (3 1/4 inches) at B
is correct
g027343
3. Transport lock
g009196
3. Measure here from the
blade tip to hard surface
4. Measure at A and B on
both sides
10. If needed, loosen the locknut on the side of
the yoke and the jam nut on top. Fine tune the
screw adjuster by turning it to attain the 7.6 mm
(3 inch) height (see
To increase the height, turn the adjuster screw
clockwise; to decrease the height, turn it
counterclockwise.
1. Locknut
2. Adjuster screw
11. If the front deck links do not have enough
adjustment to achieve accurate cut height, you
can use the single-point adjustment to gain
more adjustment.
12. To adjust the single-point system, loosen the 2
bolts at the bottom of the height-of-cut plate.
Refer to Figure
1. Bolts at the bottom of the height-of-cut plate
58
Figure 86).
Figure 86
3. Jam nut
4. Yoke
87.
Figure 87
g010251
g027345