Toro Z Master Commercial 3000 Series Operator's Manual page 15

Choke Knob
Use the choke knob to start a cold engine.
1. Pull up the choke knob to engage the choke
before using the ignition switch
2. Push down the choke to disengage the choke
after starting the engine
1. O position
N
Blade-Control Switch (PTO)
Use the blade-control switch (PTO) is used to engage
the electric clutch and drive the mower blades. Pull
the switch up to engage the blades and release. To
disengage the blades, push the blade-control switch
(PTO) down or move a motion-control lever into the
- position.
NEUTRAL LOCK
1. Turn the ignition key to the S
(Figure 9).
Note:
When the engine starts, release the key.
Figure 7
(Figure
(Figure 8).
Figure 8
2. O position
FF
position
TART
Important:
more than 5 seconds at a time. If the engine
fails to start, wait 15 seconds between
attempts. Failure to follow these instructions
can burn out the starter motor.
Note:
the engine the first time after adding fuel to an
empty fuel system.
g008946
8).
2. Turn the ignition key to the S
the engine.
Ignition Switch
Use this switch to start the mower engine and has 3
positions: S
Motion-Control Levers
Use the motion-control levers to drive the machine
forward, reverse, and turn either direction.
Fuel Shutoff Valve
The fuel-shutoff valve is located under the seat. Move
the seat forward to access it.
g008959
Close the fuel shutoff valve when transporting,
maintaining, or storing the machine.
Ensure that the fuel-shutoff valve is open when
starting the engine.
15
Do not engage the starter for
You may need multiple attempts to start
Figure 9
, R , and O .
TART UN FF
g008947
position to stop
TOP