Stopping The Machine; Adjusting The Height Of Cut - Toro Z Master Commercial 3000 Series Operator's Manual

Stopping the Machine

To stop the machine, move the traction-control levers
to neutral and then to the
disengage the power takeoff (blade-control switch
(PTO), and turn the ignition key to the
Set the parking brake when you leave the machine;
refer to Setting the Parking Brake (page
the key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.

Adjusting the Height of Cut

Using the Transport Lock
The transport lock has 2 positions and is used with the
deck-lift pedal. There is a
position for the transport position of the mower deck
(Figure 22).
- position,
NEUTRAL LOCK
position.
OFF
20). Remove
position and a
LOCK UNLOCK
Transport Lock Positions
1. Transport lock
2. Lock position—The
mower deck locks into
the position.
TRANSPORT
Adjusting the Height-of-Cut Pin
Adjust the height of cut from 25 to 140 mm (1 to
5-1/2 inches) in 6 mm (1/4 inch) increments by moving
the clevis pin into different hole locations.
24
Figure 22
3. Unlock position—The
mower deck does not
lock into the
TRANSPORT
position.
g032377