Adjusting The Motion-Control Damper; Adjusting The Motion-Control Neutral-Lock Pivot - Toro Z Master Commercial 3000 Series Operator's Manual

5. Start the engine.
Important:
Before you can start the
engine, the brake must be engaged and the
motion-control levers must be out. You do
not need to be in the seat because of the
jumper wire is in use. Run the engine at full
throttle and release the brake.
6. Run the machine at least 5 minutes with the
motion-control levers at full forward speed
to bring the hydraulic fluid up to operating
temperature.
Note:
The motion-control lever must be
in neutral while making any necessary
adjustments.
7. Bring the motion-control levers into the N
position.
8. Adjust the length of the pump-control rod by
rotating the double nuts on the rod in the
appropriate direction until the wheels slightly
creep in reverse
1. Double nuts
9. Move the motion-control levers to the R
position, and while applying slight pressure to
the lever, allow the reverse indicator springs to
bring the levers back to neutral.
Note:
The wheels must stop turning or slightly
creep in reverse.
10. Shut off the machine.
(Figure 78).
Figure 78
11. Remove the jumper wire from the wire harness
and plug the connector into the seat switch.
12. Remove the jack stands.
13. Raise the deck and install the height-of-cut pin.
14. Check that the machine does not creep in
neutral with the parking brakes disengaged.
Adjusting the
Motion-Control Damper
You can adjust the top damper-mounting bolt to obtain
the desired motion-control lever resistance. Refer to
Figure 79
EUTRAL
1. Torque the locknut to 23 N-m (17 ft-lb). The bolt must
protrude past the end of the locknut after torquing.
2. Most resistance (firmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
Adjusting the
Motion-Control
g010187
Neutral-Lock Pivot
You can adjust the flanged nut to obtain the desired
motion-control lever resistance when moving it to the
N -L
EUTRAL
EVERSE
options.
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired
feel.
•
For more resistance, tighten the flanged nut.
•
For less resistance, loosen the flanged nut
54
for mounting options.
Figure 79
Right Motion Control Shown
position. See Figure 80
OCK
g008620
for adjustment