Toro Z Master Commercial 3000 Series Operator's Manual page 38

Changing the Engine Oil
Service Interval: After the first 8 hours
Every 100 hours (more often in dirty or dusty
conditions).
Note:
Dispose of the used oil at a recycling center.
1. Start the engine and let it run for 5 minutes.
Note:
This warms the oil so that it drains better.
2. Park the machine so that the rear is slightly
lower than the front to ensure that the oil drains
completely.
3. Disengage the PTO, move the motion-control
levers to the N
EUTRAL
parking brake.
4. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position
Figure 45
-L position, and set the
OCK
(Figure 45).
5. Slowly pour approximately 80% of the specified
oil into the filler tube and slowly add the
additional oil to bring it to the Full mark
46).
g008804
6. Start the engine and drive to a flat area.
7. Check the oil level again.
Changing the Engine-Oil Filter
Service Interval: Every 200 hours
Note:
Change the engine-oil filter more frequently
when operating conditions are extremely dusty or
sandy.
1. Drain the oil from the engine; refer to
the Engine Oil (page
2. Change the engine-oil filter
g027734
38
Figure 46
Changing
38).
(Figure 47).
(Figure
g027660