Setting The Time And Date; Setting The Hdmi ™ Audio Mode - Toshiba REGZA 42LX196 Operating Manual

Setting the time and date

Note: If you already set up the TV Guide On Screen
the time and date were set automatically and you can skip this
step.
To set the time and date:
Press Y and open the Setup menu.
1
Highlight Installation and press T.
2
3
(A new set of Installation menu icons will appear, as
shown below.) Open the Time And Date menu,
highlight Start Setup, and press T.
Time And Date
Start Setup
Navigate
ENTER Select
If you have not set up the TV Guide On Screen
the following screen will appear. To set the time, highlight
TV Guide On Screen
™
On Screen setup sequence will start, and the time and
date will be set automatically.
Time And Date
Your TV Guide On Screen system can provide accurate
time and date information.
It is recommended you set up TV Guide On Screen
first and use it to obtain the time and date.
Manual TV Guide On Screen
If you have already set up the TV Guide On Screen
system, or if you have not set up the time, the Time and
Date setting screen will appear and you will need to
manually set the time and date.
Time And Date
Date (MM/DD/YY)
Time (HH:MM)
In the event that your TV Guide On Screen system
has acquired time, the television will use network
acquired time rather than manually enterred time.
Cancel
Note:
• If you highlight TV Guide On Screen
time and date through the TV Guide On Screen
a power outage occurs, the time and date will be updated
automatically when the power is restored.
• If you highlight Manual (above) to set the time and date
manually and a power outage occurs, you will lose the time
and date settings when the power is restored.
• If you manually set the time and date and then perform
™
TV Guide On Screen setup, the manual time and date
settings will be overridden by the TV Guide On Screen
settings.
Chapter 4: Setting up your TV
™
system,
Back Exit
CH RTN EXIT
™
system,
and press T. The TV Guide
™
Cancel
™
0 6 3 0 / 0 5 /
1 1 1 1 AM :
Done
™ (above) to set the
™
system and
™
Setting the HDMI
To set the HDMI audio mode:
Press Y and open the Setup menu.
1
2
Highlight HDMI 1 Audio and press c.
3
Press b or B to select the HDMI audio mode (Auto,
Digital, or Analog) and press T. (Auto is the
recommended mode.) See "Connecting an HDMI or DVI
device to the HDMI input" (- Installation Guide).
Setup
Installation
Sleep Timer
On/Off Timer
PC Settings
PC Audio
HDMI 1 Audio
Slide Show Interval
Navigate Select
ENTER
Note: Because the PC IN and HDMI (DVI) IN inputs share the
same set of analog audio inputs, the PC Audio menu setting
influences the HDMI 1 Audio menu setting. If PC Audio is set
to "No," the HDMI 1 Audio setting changes to "Auto." If PC
Audio is set to "Yes," the HDMI Audio setting is set to "Digital"
and is grayed out in the menu. (Also see item 2 on page 8 and
"Setting the PC Audio mode" on page 51.)
™ audio mode
Auto
Digital
Analog
No
Auto
2 Sec
Back Exit
CH RTN EXIT
27