Cylinder Head Cover
Install the cylinder head cover and the gasket, then tighten
the four cylinder head cover bolts diagonally to the specified
torque.
Cylinder head cover bolt: 8 N·m (0.8 kg-m; 6.0 lb-ft)
NOTE:
Make sure that the cylinder head cover gasket is installed in
the direction as shown in the figure.
Intake Manifold / Thermostat
1. Install the thermostat to the cylinder block.
2. Install the intake manifold and the gasket, then tighten
the four intake manifold bolts diagonally to the specified
torque.
Intake manifold bolt: 10 N·m (1.0 kg-m; 7.0 lb-ft)
Oil Pump / Oil Filter
1. Apply engine oil to the inner / outer oil pump.
2. Install the inner / outer oil pump to the crankcase as
shown in the figure.
3. Install the plate and the oil filter / holder to the crankcase.
POWERHEAD
REASSEMBLY
Upper Side
6-39