Plan The Installation - Kohler K-2593-VBW-0 Installation Manual

Transducer Wires
Optional Auxiliary-In
Cable
Chromatherapy
Cable (If Equipped)

Plan the Installation

For best results, follow the installation sequence below. Detailed instructions are found on the following
pages of this guide.
Recommended Installation Sequence
Determine the locations for the bath components. Refer to the illustration for preferred locations.
Plan the required access panel location for servicing the control amplifier.
Route plumbing supply lines.
Prepare the bath rim, if using a rim-mount faucet.
Mark and install the drain pipe.
Install the bath shroud.
Bind all cables in preparation for the bath installation.
Install an electrical outlet within 24" (610 mm) of the control amplifier location.
Install an electrical outlet within 24" (610 mm) of the junction box on the control board.
Install the bath and drain. Route the bound cables through the bottom of the shroud.
Route the transducer wires to the control amplifier location.
If equipped, route the chromatherapy cable to the control amplifier location.
Route the user interface cable to the user interface location.
Route the inter-connect cable to the control amplifier.
Connect the transducer wires, inter-connect cable, optional auxiliary cable, and chromatherapy cable
(if equipped) to the control amplifier.
Install the control amplifier.
Install the access panel for the control amplifier.
Connect the user interface cable to the user interface, and install the interface.
Connect the control amplifier and junction box cables to the electrical outlets.
1237790-2-D
Inter-Connect
Cable
Heated Surface
Control
4
User Interface
Transducer
Control
Kohler Co.