3 Configure LonWorks points using the LonWorks Integration Tool
9
Click the disk-in-folder icon
10 Return to the i-Vu® or Field Assistant interface.
11 Double-click the third party controller in the navigation tree. A dialog window appears.
12 Navigate to Integration Points at the bottom of the screen and click Import.
13 Browse to the .erl file that you saved from the LonWorks Integration Tool.
14 Click Open and then Continue to upload the file.
15 Click Close. The LonWorks addresses are now set
NOTE The LonWorks Integration Tool creates microblock addresses in the following format:
lonworks://domain index/subnet/node/NV number/SNVT index/element/NV parameter/group
EXAMPLE
lonworks://0/1/2/3ff5/108/0/0/0
To edit an integration point address
You can edit an integration point address in the following places:
•
In Snap
•
In the i-Vu® or Field Assistant interface on the Properties page > Control Program tab
•
In the i-Vu® or Field Assistant interface on the Properties page > Network Points tab
•
In the LonWorks Integration Tool
LonWorks Integration Guide
i-Vu® Link and Open Link
to save a .erl file with your microblock addresses.
8
CARRIER CORPORATION ©2018
All rights reserved