Local Codes; Unpacking; Product Features - Superior Fireplaces VRT4032ZEN Installation And Operation Instructions Manual

LOCAL CODES

Install and use appliance with care. The installation
must conform with local codes or in the absence
of local codes, to the latest edition of The National
Fuel Gas Code, ANSI Z223.1/NFPA54*. Firebox
must be electrically grounded in accordance with
the National Electrical Code, ANS/NFPA70* (latest
edition).
*Available from:
American National Standards Institute, Inc.
25 West 43rd Street, 4th fl oor
New York, NY 10036
National Fire Protection Association, Inc.
1 Batterymarch Park
Quincy, MA 02169-7471
COMMONWEALTH OF MASSACHUSETTS RE-
QUIREMENTS
These appliances are approved for installation in
the US state of Massachusetts if the following ad-
ditional requirements are met:
• Un-vented Room Heaters shall be installed in
accordance with 527 CMR 30.
• Installation and repair must be done by a
plumber or gas fi tter licensed in the Common-
wealth of Massachusetts.
• The fl exible gas line connector used shall not
exceed 36 inches (92 centimeters) in length.
• The individual manual shut-off must be a T-
handle type valve.
• Un-vented appliances may NOT be installed in
bedrooms or bathrooms.
• A working smoke detector must be installed
in the area where vent-free appliances are in-
stalled.
Seller of un-vented propane or natural gas-fi red
supplemental room heaters shall provide to each
purchaser a copy of 527 CMR 30 upon sale of the
unit.
900719-00D
CAUTION: Do not remove the data
plates attached to the heater base as-
sembly. The data plates contain impor-
tant warranty and safety information.
1. Remove logs and appliance base assembly
from carton(s).
NOTE: Do not pick up appliance base assembly
by burners. This could damage the appliance.
Always handle base assembly by grate.
2. Remove all protective packaging applied to logs
and appliance for shipment.
3. Check appliance for any shipping damage. If
appliance is damaged, promptly inform dealer
where you purchased the appliance.
OPERATION
This vent-free fi replace is clean burning. It requires
no outside venting. There is no heat loss out a vent
or up a chimney. Heat is generated by both realistic
fl ames and glowing embers. When used without the
blower, the fi replace requires no electricity making it
ideal for emergency backup heat.
SAFETY DEVICE
This fi replace has a pilot with an Oxygen Depletion
Sensing (ODS) safety shutoff system. The ODS/pilot
is a required feature for vent-free room heaters. The
ODS/pilot system shuts off the fi replace if there is
not enough fresh air.
ELECTRONIC IGNITION SYSTEM
This heater has an electronic igniter to light the
fi replace's fuel supply.
BLOWER ASSEMBLY
This fi replace includes a blower assembly. The blower
operates thermostatically and features a variable
speed control. The blower circulates heated air from
the fi replace into the room.
SuperiorFireplaces.us.com

UNPACKING

PRODUCT FEATURES

5