Review Questions (Cutting Units) - Toro GROUNDSMASTER 325-D Troubleshooting Manual

TORO GM 345/325-D
1. Bearings and spacers should be replaced as a
set
a. True
b. False
2. The drive belt engagement spring should be
adjusted to a length of:
a. 2 1/4 inches
b. 3 3/16 inches
c. 1 1/2 inches
d. 4 inches
3. The cutting unit raise/lower lever should be in
the neutral position when mowing
a. True
b. False
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
Review Questions
4. Balancing the blade after sharpening is not
a. True
b. False
5. The small spacer ring fits in a groove in the
a. True
b. False
6. The PTO drive belt alignment is not adjustable
a. True
b. False
Notes
Cutting Units
necessary.
spindle shaft.
81