Correction; Carburetor Linkage Adjustment - Toro GROUNDSMASTER 325-D Troubleshooting Manual

TORO GM 345

Correction:

Carburetor linkage adjustment.

1. With the engine shut off, move the throttle control to the FAST position.
2. Check the gap between the throttle arm and the stop on the carburetor base. The correct gap is 1/32"
(0.78mm).
3. If the gap is not correct adjust the throttle rod by turning the ball joint until the proper gap is attained.
This adjustment insures that the carburetor throttle plate can fully open under a load, but the linkage will not
bottom out against the stop.
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
_______________________________________________________________________________________________________________
Ford VSG-411 Gas Engine
Notes
9