Using The Telephone; Making A Call - Geemarc PHOTOPHONE 450 Manual

USING THE TELEPHONE

USING THE TELEPHONE

Making a Call

Pick up the handset.
When you hear the dialling tone, dial the number on the keypad.
To end the call simply replace the handset in the cradle
Making a Call – Hands Free (speakerphone)
Press the button to hear the dialling tone then dial the telephone
number on the keypad. The icon appears on the LCD. To end
the call, simply press again. The icon will disappear.
To activate the Hands Free function during the call, press the
button and replace the handset on the cradle at the same time.
To deactivate the Hands Free function during a call, lift the handset.
When in handset mode changed to hands free, press more
than 3 seconds the, The icon will disappear.
Note: When in hands free mode, only one person may talk at a time.
The switch-over between speaker and microphone is automatic.
This is dependent on the sound level of the incoming call and the
microphone respectively. It is therefore essential that there are no
loud noises, e.g. music, in the immediate vicinity of the telephone, as
this will disrupt the hands free function.
Speakerphone Volume Setting
You can adjust the speakerphone volume by using the volume slider
control labelled Speaker Phone - located on the left side of the
telephone base.
Pre-Dialling a Telephone Number
You can enter the desired phone number in standby mode, which
allows you to make corrections before dialling. Follow these steps:
Enter a telephone number (up to 22 digits). Check it. If you make a
DELETE
mistake while entering a number, press the button to edit it.
OK
When the number appears correctly, lift the handset, press or
press the button.
16