Citizen CLP-6001 User Manual page 49

All manuals and user guides at all-guides.com
Indication
RibonOut Ribbon end
OverHeat PCB overheat
Fan stop Fan stop
OP Err Option board
abnormality
Cut Err Auto-cutter
abnormality (such as
poor engagement)
ROM Err ROM checksum error
RAM Err RAM checksum error
− −
System error (such as
timer or CPU
malfunction)
Description
Check the contents and clear with the Stop
key.
Install the ribbon.
Check that the ribbon winds fully.
Correct the faulty setting of the print mode
(direct-thermal or thermal-transfer).
Turn off the power and reset the printer.
If this recurs, contact our service personnel.
Check for the fan stop caused by the problems
such as foreign matter entered in the air vent.
Automatically returned if the fan turns again.
If disassembling is needed to remove foreign
matter or the problem can't be identified,
contact our service personnel.
Turn off the power and reset the printer.
If this recurs, contact our service personnel.
Check the contents and clear with the Stop
key.
If this can't be cleared, turn off the power and
remove foreign matter from the auto-cutter.
If this recurs, contact our service personnel.
Turn off the power and reset the printer.
If this recurs, contact our service personnel.
Turn off the power and reset the printer.
If this recurs, contact our service personnel.
First protect the system, then reset the printer.
4-6
Corrective actions