Citizen CLP-6001 User Manual page 48

All manuals and user guides at all-guides.com
Indication
OverHeat Head overheat
Cooling
Stop Stop key pressed
Cancel Stop command
reception
(communication
control)
HeadOpen Mechanism head
open
PaperEnd Paper end (no paper
left)
PaperErr Paper out (paper
position can't be
detected)
Description
Wait until the head temperature goes down.
When the temperature becomes low, the
remaining printing resumes.
Enters a pause after displaying the stop by the
Stop key.
If the Pause key is pressed, the printing will
resume.
If the Stop key is pressed again, the stored
printing contents will be lost and "on line" will
turn on.
Displays the stop by the stop command,
discards the stored printing contents, and
enters a pause.
If the Pause key is pressed, "on line" will turn
on.
Close the mechanism head.
Install the paper.
Check the contents and clear with the Stop
key.
Correct the faulty setting of the paper detection
(paper gap, black line, continuous paper).
Correct the faulty parameter for paper (max.
length, continuous paper).
Adjust the sensor or change for the paper that
accepts the paper position detection.
Specify the length for detection miss checking
with the M command.
When the paper position can't be detected
during paper feeding by the specified length, it
is judged error.
about three times the label length.
In case of the continuous paper, specify the
label length with the C c ommand.
Difference between the maximum and
minimum values of the sensor reading voltage
must be 0.8 V or more.
Sensor adjustments and paper characteristic
verification (voltage verification) can be
performed with the Maintenance mode.
4-5
Corrective actions
Generally specify the length