Roland CAMM-3 PNC-3200 User Manual page 25

5
Secure the spindle motor so that it does not rotate, and
use wrenches to tighten securely.
22 mm
(0.87 in.)
Changing the Collet Chuck
The collet chuck included as standard equipment with the machine
can hold a cutting tool with a shank that is 6 mm (0.24 in.) in
diameter. When using a cutting tool that has a different shank
diameter, be sure to replace the collet chuck with one suited to the
cutting tool's shank diameter. (Collet chucks for shank diameters
other than 6 mm (0.24 in.) are available separately.)
1
Rotate the collet cap to remove it.
Collet cap
3
Securely fit the groove on the collet chuck to the tab
on the cap.
Groove
Tab
30 mm
(1.18 in.)
Good example
Bad examples
6
Set the SPINDLE switch to ON.
LED Lights up
Cutting tool
shank
2
Tilt the collet chuck at an angle and remove while
twisting.
4
Install on the spindle.
Shank diameter
23