IBM 3745 Series Connection And Integration Manual page 75

Step 3
Pull out the plug.
If you are not plugging in an AUI, go to Step 6 on page 3-11.
Otherwise, continue with the next step.
Step 4
Plugging in an
AUI
cable
Repeat this step for every AUI to be plugged in.
Note: Make sure that all the cables are correctly labeled at both ends
before doing this step.
1. Locate a cable with a label. Find the port that matches the cable.
2. Slide the latch to the left.
3. Hold the cable connector so that its longest side is upward.
•
000000000000
0 0 0 0 0 0 0 0 0
•
4. Push the plug strongly into the port connector.
D
o
5. Push the locking latch to the right to lock it. It may reguire a lot of
0 : ' ...
~"
force to move it.
3-10
3745 All Models & 3746-900: CIG