IBM 3745 Series Connection And Integration Manual page 108

0
0
0
0
o
Step
8
Step 9
Step 10
Step 11
Step 12
Step 13
@]@]08
To start the upgrade:
0 8
Wait until one of these messages is displayed:
• CDF UPGRADE COMPLETED
This means that all of the power supplies are functioning, go to Step
13.
• SOME INSTALLED POWER SUPPLIES ARE NOT UP
This means that not all of the power supplies are functioning,
continue with the next step.
Confirm or cancel the upgrade. If you confirm the upgrade, any power
supplies not functioning are considered as not installed, and any lines
depending on that power supply cannot be upgraded.
To confirm:
0 8
and go to Step 13.
To cancel:
o (
Enter
I
and continue with the next step.
If you want to perform the MOSS power services (POS) function:
§J
and, if necessary, refer to POS in the Advanced Operations Guide,
SA33-0097. After performing the POS, return to Step 8 to repeat the
CDF upgrade.
Otherwise, continue with the next step.
§]
If you want to change any line parameters, go to "Update Procedure" on
page 5-10.
Otherwise, continue with the next step.
Step 14
CD 0
[g
8
Step 15
If you have a dual CCU controller:
CD
or
0
or
CD
then
CD
or
0
then (
Enter]
Otherwise, continue with the next step.
Step 16
CD
or
0
then
8
If you are loading the control program from the 3745 fixed disk (using
the MOSS DII function), go to Step 19.
Otherwise, continue with the next step.
Chapter 5. Integration Procedures
5-9