IBM 3745 Series Connection And Integration Manual page 33

Step 2
Unplugging a TRA cable.
Repeat this step for every TRA cable to be unplugged.
1. Remove the cable by squeezing the levers and pulling out the
plug.
2. Replace the protective cap on the cable plug.
Protective Cap /
If you are not plugging in a TRA cable, go to Step 6 on page 1-13.
Otherwise, continue with the next step.
Step 3
Plugging in a TRA cable.
Repeat this step for every TRA cable to be plugged in.
Note: Make sure that all the cables are correctly labeled at both ends
before doing this step.
a. Refer to the figure of the Step 2.
b. Locate the cable with a label that matches its port number.
c. Remove the protective cap from the cable plug.
d. Hold this plug with the levers on the sides, squeeze both levers,
and push the plug strongly into the port.
Step 4
Upgrade CDF
You must perform the Upgrade procedure in "Upgrading or Updating
CDF" on page 5-7. You can either do it now and continue with the next
step or later when you have finished all your connection procedures.
1-12
3745 All Models & 3746-900: CIG
o
..
/
-
",
•
o