Tiger JD 5083E Mounting And Operating Instructions page 83

Cheetah boom assemblies
Hide thumbs Also See for JD 5083E:
Table of Contents

Advertisement

SYMPTOMS
Mower will not start
or run, cont.
Motor runs but
will not cut.
Motor turns slowly
or not at all.
Pump will not work
Motor will not work
NOTE:
If flow meter is available, check pressure and flow volume for all
suspected hydraulic problems.
If the solution to your problem cannot be found in this section, call the
Technical Service representative at the number shown on the front cover of
MAINTENANCE
CAUSE
1. Electronic
solenoid faulty
1. Belts
2. Tensioner
1. Contaminants
restricting spool
movement in
valve body.
2. Suction lines
obstructed
3. Low oil level
1. Excessive wear
on internal parts
1. Excessive wear
on internal parts
Cheetah Maintenance Section 4-5
REMEDY
1a. Without the tractor running, turn
the mower switch to on. A low
audible click should be heard if the
solenoid is engaging the solenoid
spool. If click is not heard, leave
switch in on position and with a
screwdriver or other steel object,
touch the small nut on the end of the
solenoid. If the metallic object is not
attracted to the nut, check the fuse
and wiring for an open circuit. If the
object is attracted but no "click" is
heard, replace the solenoid.
1b. Remove the four bolts holding the
small block to the main block. Lift
and remove small block being
careful not to damage O-rings / filter.
Clean filter and re-install.
1c. Remove large nut on side of large
valve block. Remove spring, and use
needle nose vise grip to pull spool
from block. Check block and spool
for contaminates and scratches.
Clean parts or replace if scratched.
1. Inspect belts and pulleys. Replace
belts and repair as needed.
2. Adjust tensioner nut until flat washer
washer is flush with top of guide.
1. . Remove large nut on side of large
valve block. Remove spring, and use
needle nose vise grip to pull spool
from block. Check block and spool
for contaminates and scratches.
Clean parts or replace if scratched.
2. Check for kinkes or obstruction in
suction hose
3. Check Hyd. tank level and fill
1. Disassemble and repair.
1. Disassemble and repair.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents