Daikin FTX-N Series Service Manual page 104

Inverter pair: wall mounted type, floor standing type, duct connected type.
Hide thumbs Also See for FTX-N Series:
Table of Contents

Advertisement

BRC082A43
DISPLAY "
" " I " (SIGNAL TRANSMISSION)
1
This lights up when a signal is being transmitted.
DISPLAY "
" "
(OPERATION MODE)
2
This display shows the current OPERATION MODE.
H
M
L
DISPLAY "
" (SET TEMPERATURE)
3
F
This display shows the set temperature.
DISPLAY "
hr.
hr.
4
This display shows PROGRAMMED TIME of the
system start or stop.
DISPLAY "
" "
5
This display shows the set fan speed.
DISPLAY "
TEST
OPERATION)
6
When the INSPECTION/TEST OPERATION BUTTON
is pressed, the display shows the system mode is in.
ON/OFF BUTTON
7
Press the button and the system will start. Press the
button again and the system will stop.
FAN SPEED CONTROL BUTTON
8
Press this button to select the fan speed (HIGH,
MEDIUM or LOW) of your choice.
TEMPERATURE SETTING BUTTON
Use this button for SETTING TEMPERATURE.
9
(Operates with the front cover of the remote controller
closed.)
PROGRAMMING TIMER BUTTON
Use this button for programming "START and/or STOP"
10
time. (Operates with the front cover of the remote
controller opened.)
99
" "
" "
" "
"
" (PROGRAMMED TIME)
" "
" (FAN SPEED)
" (INSPECTION/ TEST
TIMER MODE START/STOP BUTTON
11
Use this button for TIMER MODE setting.
TIMER RESERVE/CANCEL BUTTON
12
Use this button to end timer setting procedure.
OPERATION MODE SELECTOR BUTTON
13
Press this button to select OPERATION MODE.
FILTER SIGN RESET BUTTON
14
Refer to the section of MAINTENANCE in the operation
manual attached to the indoor unit.
INSPECTION/TEST OPERATION BUTTON
15
This button is pressed for inspection or test operation.
Do not use for normal operation.
EMERGENCY OPERATION SWITCH
16
This switch is readily used if the remote controller does
not work.
RECEIVER
17
This receives the signals from the remote controller.
OPERATING INDICATOR LAMP (Red)
18
This lamp stays lit while the air conditioner runs.
It flashes when the unit is in trouble.
TIMER INDICATOR LAMP (Green)
19
This lamp stays lit while the timer is set.
AIR FILTER CLEANING TIME INDICATOR LAMP (Red)
20
Lights up when it is time to clean the air filter.
DEFROST LAMP (Orange)
21
Lights up when the defrosting operation has started.
(For cooling only type this lamp does not turn on.)
SiUS091601EA
Part 5 Remote Controller

Advertisement

Table of Contents
loading

Table of Contents