Card Reader/Usb Board - HP OMEN 17-cb0000 Maintenance And Service Manual

Card reader/USB board

NOTE: The card reader/USB board cable is available as spare part number L57363-001.
Table 6-8 Card reader board description and part number
Description
Card reader/USB board
Before removing the card reader/USB board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the fan/heat sink (see
Remove the card reader/USB board:
1. Disconnect the cable from the ZIF connector on the card reader/USB board (1).
2. Remove the Phillips M2.0 × 3.5 screw (2) that secures the board to the computer.
3. Lift the side of the board up, and then pull board up and into the computer to remove it (3).
Reverse this procedure to install the card reader/USB board.
(Preparation for disassembly on page
Bottom cover on page
Battery on page 38).
Heat sink/fan assembly on page
29).
30).
44).
Component replacement procedures
Spare part number
L57370-001
47