Usb/Audio/Card Reader Board - HP ProBook 430 G3 Maintenance And Service Manual

USB/audio/card reader board

Description
USB/audio/card reader board
USB/audio/card reader board cable (included in Cable Kit)
Before removing the USB/audio/card reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Service door (see
b. Hard drive
c. Keyboard (see
d. Top cover (see
Remove the USB/audio/card reader board:
NOTE: Before you remove the card reader, make sure nothing (memory card or plastic insert) in installed.
1. Position the top cover upside-down.
2. Disconnect the large ribbon cable from the board (1).
3. Disconnect the small touchpad ribbon cable from the board (2).
4. Remove the Phillips PM2.5×5.0 screw (3) that secures the board to the computer.
Battery on page
Service door on page
(Hard drive on page 35)
Keyboard on page 44)
Top cover on page 49)
33).
34).
Component replacement procedures
Spare part number
826374-001
826373-001
59