Usb/Card Reader/Power Button Board - HP 245 G7 Maintenance And Service Manual

USB/card reader/power button board

Table 5-15 Spare part description and number
Description
USB/card reader/power button board
USB/card reader/power button board cable
Before removing the USB/card reader/power button board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the display (see
Remove the USB/card reader/power button board:
1. Disconnect the cable from the ZIF connector on the USB/card reader/power button board (1).
2. Remove the two Phillips M2.0 × 3.0 screws (2), and then remove the board from the computer (3).
Reverse this procedure to replace the USB/card reader/power button board.
(Preparation for disassembly on page
Bottom cover on page
Battery on page 29).
Display assembly on page
27).
50).
Component replacement procedures
Spare part number
L23196-001
L23186-001
26).
49