Software Setup Troubleshooting - Plustek OpticFilm 8200i Ai User Manual

Software Setup Troubleshooting

Carefully review the steps outlined in this guide and the Quick Installation Guide that
accompanied your scanner.
If you are still having problems, please check that:
 You have 10 GB of free space on your hard disk drive.
 The scanner is plugged in and has power.
 You are using the USB cable supplied with the scanner.
 The square end of the USB cable is plugged into the rear of the scanner.
 The rectangular end of the USB cable is plugged into the back of your computer.
If you deviated from the installation procedures defined in this manual, please unplug
the USB cable from the scanner and reinstall the software from the CD-ROM. To
reinstall your scanner's software, click [Start], [Run], then type [D:\Install] (where D
represents the letter of your CD-ROM drive). Carefully follow all the installation
instructions presented in the Setup Wizard. Reboot your computer when prompted,
and plug the USB cable back into the scanner while your computer is still turned on.
4. Follow
instructions to install all software
that your new USB scanner
requires.
5. After the software is installed,
close all open applications and
click on the [Finish] button to
restart your computer.
14
the on-screen