Plustek OpticFilm Series Quick Start Manual

OpticFilm series Quick Start Guide
1
Unpack and Connect
Scan me -- Installation Tutorial video
If you are installing the software without a CD/DVD drive, please refer to
rear side of this guide.
2
Install Software
Insert the product CD and run your product's software package.
3
Unlock SilverFast
1.
Check Image Source and Language Selection, then click Start.
If the Image Source is blank, please check if your scanner is
Attention
properly listed under [Imaging Devices] in [Device Manager].
* 35 mm IT-8 Target (Only for OF8200i Ai)
For Mac/PC without a CD/DVD drive
2.
Enter your First name, Last name, and the Serial number, then click Unlock.
* The SilverFast DVD-ROM should remain in the DVD-ROM drive for the Unlock process.
Place Film in the Holder
* You do not have to install any scanner drivers when
installing the scanner under Mac OS. The scanner drivers
are already included within the SilverFast installation.
The SilverFast serial number is located on the front of the SilverFast
DVD-ROM case.
section on the