ResMed VPAP II User Manual page 13

4
Start the flow generator in one of the following ways:
Figure 2 : VPAP II front panel
S /S
Press the 5VCTV5VQR button to start the air flow. The air will begin flowing slowly
TART TOP
and build up to pressure in 10–15 seconds.
OR
D T
ELAY IMER
If you have difficulty falling asleep with full pressure, you can use the Delay Timer.
The airflow will start very gently while you fall asleep, and slowly increase to full
operating pressure over a selected time period. You can select a delay time of 5, 10
or 20 minutes.
Choose a delay time and press the corresponding button. The air will start to flow
automatically. There is no need to push the 5VCTV5VQR button. If you have not yet
fallen asleep after the delay period, you may press one of the &GNC[ 6KOGT buttons
again.
OR
S S ®
MART TART
This feature is set by your clinician. If SmartStart is enabled, the hand icon will
appear on the LCD screen (see "LCD Screen" on page 13) and the flow generator
will automatically start when you breathe into the mask, and stop when you remove
it. If you want to use the Delay Timer, you will need to press a &GNC[ 6KOGT button
to start treatment. However, the flow generator will still stop automatically.
10
MODE S
IPAP 10.0
EPAP
8.0
IPAP max
2.0
MIN
Start/Stop
button
RESMED
VPAPIIST
5 10 20 Alarm Cancel
Delay Timer buttons button